+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Jessada Rabbit bit screw (/showthread.php?tid=7375556)
Jessada Rabbit bit screw - DaveBozeman - 04-04-2024
Anyone know what the thread size for this rabbit bit might be? I know it's a long shot.. thanks in advance
RE: Jessada Rabbit bit screw - museumguy - 04-04-2024
(04-04-2024, 05:38 PM)DaveBozeman Wrote: Anyone know what the thread size for this rabbit bit might be? I know it's a long shot.. thanks in advance
If I remember correctly, most bits use a 3-48 screw. I do know that Freud is a different size. Do you need a screw? I had to buy a whole box once, I think that I used like 5 over the years.
RE: Jessada Rabbit bit screw - DaveBozeman - 04-05-2024
Yes, the Freud seems to be 3mm X. 5.. for the Jesada I'll look for a 3-48.. thank you.. I'll pick one up, give it a try
I bought a replacement bearing set by Amana, it came with 2 screws that don't seem to fit either set, but the bearings are nice
RE: Jessada Rabbit bit screw - museumguy - 04-05-2024
Are you missing the screw or just need a different one? I believe that typically Amana uses 3-48. It's been a number of years, but I used to know this information like the back of my hand.
RE: Jessada Rabbit bit screw - DaveBozeman - 04-13-2024
I'm thinking that maybe the bits threads are messed up.. so I don't have one that seems to fit.. tomorrow I'll try to clean out the threads
RE: Jessada Rabbit bit screw - KC - 04-14-2024
If you have any other Jesada (and probably Infinity) bits, you can 'borrow' a screw from them.