10-05-2015, 05:13 PM
Trying to surface joint some Hickory that I had sawed up after tornadic activity a few years ago. I am building farmhouse table.
When I joint the lumber I am getting a taper across the width of the boards.
I started out with two inch material and now I have 1 3/4 on one side and much less on the other. I had to do multiple passes to get a bow out.
Any ideas why I'm seeing this taper.
Thanks
When I joint the lumber I am getting a taper across the width of the boards.
I started out with two inch material and now I have 1 3/4 on one side and much less on the other. I had to do multiple passes to get a bow out.
Any ideas why I'm seeing this taper.
Thanks