03-25-2017, 06:25 PM
I'm making a coin display for someone.
The main board has a 30* bevel on the bottom so it leans back.
It's to be supported by a leg glued to the back which is beveled to match.
The rear of the leg is beveled parallel to the front.
How do I clamp this so the bottom of the main board and the leg stay aligned?
The main board has a 30* bevel on the bottom so it leans back.
It's to be supported by a leg glued to the back which is beveled to match.
The rear of the leg is beveled parallel to the front.
How do I clamp this so the bottom of the main board and the leg stay aligned?
Gary
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.
Please don’t quote the trolls.
Liberty, Freedom and Individual Responsibility
Say what you'll do and do what you say.