12-21-2015, 04:27 PM
I started reinstalling my cartridge and blade on my SS after it was triggered. It just doesn't feel right. The blade sits about 1/2 inch from the riving blade and also at least that much on the Sharkguard. I know you're supposed to lower the mechanism to the lowest point and it's supposed to reset the arbor and I did that.
Also I never checked before but the blade is supposed to be 3 1/8 above the table and mine is 3 inches. What is weird is the insert which would have been cut by that original blade is wider than the blade at it's highest point.
I'm not sure if I have done everything correct.
Also I never checked before but the blade is supposed to be 3 1/8 above the table and mine is 3 inches. What is weird is the insert which would have been cut by that original blade is wider than the blade at it's highest point.
I'm not sure if I have done everything correct.