I have to ask a stupid question guys. I can't remember the needed dimensions I have cut a flag box on before. Any help please so I don't waste the walnut
The critical consideration is the size of the flag and the're many sizes thus when folded will require different dimensions . If at all possible, get your hands on the flag and fold it or ask whom ever you are making this for, the folded dimensions of the flag.
I have the flags ill be going about 18 inchs by 26 roughly. thanks
IIRC, the ID for the short side is 15-1/2" and 21-1/2" for the base for an honor flag.
Roughly 12-1/2" triangle height.
I meant to add to my last post its a 3x5 flag.
The 3 X 5 is smaller than the dimensions I posted, I haven't done that size.
Gary G™ said:
The 3 X 5 is smaller than the dimensions I posted, I haven't done that size.
There may be s source to find the folded die, but I woukd wait until I had the flags. This size is about half the size of a traditional memorial flag
Having issues with making the angle cut for the bottom right and left sides. For the bottom board and both sides what should I put the blade on for the cuts.
what angle do I cut the bottom angles where should I put the blade angle at for the bottom board and the bottom right and left corners. I have the top at 45 degrees