05-24-2022, 08:21 AM
Saturday morning, West Liberty Yard Sales, Day 2......spent $3
[attachment=42401]
Chisel is a 3/4" wide Craftsman....the block plane?
[attachment=42402]
Lever cap iron suggests this was by Sargent.....just a tad on the rusty, krusty side...we have ways...
[attachment=42403]
Sole was fairly good, for a block plane, once the rust was removed( rode on the beltsander for a few minutes)
Removed the rest of the rust and crud...
[attachment=42404]
Lever cap iron has 306, 307 stamped to it's underside, Iron has DUNLAP APPROVED BL 619.3701...but, stamped into the base, right behind the ramp to the mouth opening
[attachment=42405]
217-16....
Knob was oiled up, the 2 bolts were cleaned up, depth adjuster was removed, cleaned up and oiled up. All the missing black colour was replaced. Iron is a work-in-progress....had a line of pits to remove....and a new bevel ground....
[attachment=42406]
Top view. Base is 7-1/8" long....
[attachment=42407]
Not too bad? Better than it was, at the least.
Made by Sargent, sold at the local Sears & Roebuck store, back in the day.
Need to work on the iron a bit more, before any shavings can be made....
Will work on the chisel, as well....it's bevel is really BAD..
Stay tuned
[attachment=42401]
Chisel is a 3/4" wide Craftsman....the block plane?
[attachment=42402]
Lever cap iron suggests this was by Sargent.....just a tad on the rusty, krusty side...we have ways...
[attachment=42403]
Sole was fairly good, for a block plane, once the rust was removed( rode on the beltsander for a few minutes)
Removed the rest of the rust and crud...
[attachment=42404]
Lever cap iron has 306, 307 stamped to it's underside, Iron has DUNLAP APPROVED BL 619.3701...but, stamped into the base, right behind the ramp to the mouth opening
[attachment=42405]
217-16....
Knob was oiled up, the 2 bolts were cleaned up, depth adjuster was removed, cleaned up and oiled up. All the missing black colour was replaced. Iron is a work-in-progress....had a line of pits to remove....and a new bevel ground....
[attachment=42406]
Top view. Base is 7-1/8" long....
[attachment=42407]
Not too bad? Better than it was, at the least.
Made by Sargent, sold at the local Sears & Roebuck store, back in the day.
Need to work on the iron a bit more, before any shavings can be made....
Will work on the chisel, as well....it's bevel is really BAD..
Stay tuned