Thanks Mound.
FWW contacted me to ask permission for this one. The previous (non shoptools edition) had a method I deviced for converting high sided bench chisels into dovetail chisels in about a minute, with little effort. I was rather proud of that one.
Link to the article is here:
http://www.inthewoodshop.com/ShopMadeToo...isels.html
Regards from Perth
Derek
Nice job as always, Derek - thanks for the tip.
Doug
Way to go Derek! I shall make a point of seeking a copy!
It's not a special photo. I was prepared to write an article on all the features of this vise, such as the clamping system, spring-loaded chop, etc. I think FWW missed the boat.
The details are here:
http://www.inthewoodshop.com/ShopMadeToo...Vise2.html
Regards from Perth
Derek