Drill Bits and Morse taper sockets that take the bits - Printable Version +- Woodnet Forums (https://forums.woodnet.net) +-- Thread: Drill Bits and Morse taper sockets that take the bits (/showthread.php?tid=6937102) Pages:
1
2
|
Drill Bits and Morse taper sockets that take the bits - Arlin Eastman - 01-25-2015 Earlier this year I needed some special bits that would help me in making the wooden holders for Cigars and they had to be tight tolerance. Here is what I found and the prices are out of this world. http://www.wttool.com/index/page/categor...earch_params%3D They fit right into you MT tail stock and you never need a Jacobs chuck again. Here is an MT adapter if the bits are to small and need a MT 1 or MT 3 up to MT 5 I had a drill bit that was a MT 3 and would not fit in my MT 2 tail stock so I got the MT 2 to MT 3 this is what I did http://www.wttool.com/index/page/category/category_id/14158/ I now do ALL of my drilling with the bits and will get in the future a MT 2 to MT 1 when I need a small drill bit that is MT 1 By all I meant pen drilling too. If you see the prices they are very good and All of them Are HSS also O and also check the site because they have MM sizes from 1.0 up to 22mm http://www.wttool.com/index/page/category/category_id/14461/ Arlin Re: Drill Bits and Morse taper sockeks that take the bits - Dennis Puskar - 01-25-2015 Great prices Arlin. Can you sharpen these or do you send them out ? Re: Drill Bits and Morse taper sockeks that take the bits - Arlin Eastman - 01-25-2015 They can be sharpened like any other bit either by hand of if you have a jig. So far I have used 4 of the bits quite a lot and they are just as sharp as the day I got them. Arlin Re: Drill Bits and Morse taper sockeks that take the bits - Arlin Eastman - 08-22-2015 I thought I would bump this info Re: Drill Bits and Morse taper sockeks that take the bits - badwhiskey - 08-23-2015 Cool. I must have missed this when you first posted it. Thanks. Re: Drill Bits and Morse taper sockeks that take the bits - Arlin Eastman - 09-21-2015 Bump for anyone using drill bits Re: Drill Bits and Morse taper sockeks that take the bits - Timberwolf - 09-23-2015 I have had those taper shank bits for many years sizes from 3/16 to 1 1/4"...mostly for my metal lathe but they work fine on wood also.. I learned to sharpen twist drills by hand when I was about 14, in the machine shop. We didn't even have a "jig"... Re: Drill Bits and Morse taper sockeks that take the bits - Arlin Eastman - 09-23-2015 Jack We both know your machine shop at 14 was a stone quarry. Arlin RE: Drill Bits and Morse taper sockeks that take the bits - Arlin Eastman - 12-14-2016 Bump for info RE: Drill Bits and Morse taper sockeks that take the bits - Arlin Eastman - 03-26-2018 Hope this still helps and good info |