+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Cutting Steel siding on a Morton building (/showthread.php?tid=7316339)
Pages:
1
2
Re: Cutting Steel siding on a Morton building - Firebee - 07-11-2016
+1 You should also use a Full face shield and respirator. I only Highlighted eye protection because one exposure could result in total blindness. I felt a chip hit my cheek when doing this. Didn't bother me a bit, just made me think to warn my friends
Re: Cutting Steel siding on a Morton building - JerGar - 07-11-2016
I had to cut out some openings for doors last year.
I just used my circular saw with regular carbide wood blade.
Yea use eye protection.
The year before I cut up an old 20' Aluminum boat with the same saw and blade.
Cut it like butter got $350 for the scrap metal (700 pounds)
Re: Cutting Steel siding on a Morton building - barryvabeach - 07-12-2016
Evolutino makes a cheap saw for just this purpose- it has lower RPMs so less heat and spark, though full face protection is still suggested
This is the combo saw, https://www.amazon.com/dp/B004QX7P1Y/ref=olp_product_details?_encoding=UTF8&me= When I looked at one on Amazon last week, they were down to $88, but prices have gone up a littel. they make one that is a little more rugged for more dedicated metal cutting.
Re: Cutting Steel siding on a Morton building - rwe2156 - 07-12-2016
Use a circ saw with a carbide metal cutting blade. Cut the metal from the back side. Screw on a straight edge from the waste side.
I have a lot of experience cutting metal roofing.
Shears and nibblers are a PITA you'll see why when you cut over a ridge.
Abrasive wheels melt the paint and leave a horribly torn up edge. However, if you're using a J channel its not as critical.
BTW, for years I used a circ saw blade put on backwards (non carbide if you can find one) Works amazingly well!
No need to mention ear, eye protection and gloves are a must.
Re: Cutting Steel siding on a Morton building - sroxberg - 07-12-2016
Thanks for the suggestions, sounds like a job I may want to hire out.
Re: Cutting Steel siding on a Morton building - fixtureman - 07-13-2016
The Morton crew that built mine used a nibbler
Re: Cutting Steel siding on a Morton building - Splinter Puller - 07-13-2016
sroxberg said:
Thanks for the suggestions, sounds like a job I may want to hire out.
LOL... geez! its not that hard nor is it rocket science. Just try a test cut.
RE: Cutting Steel siding on a Morton building - kurt18947 - 07-19-2016
A steel (non-carbide) 24 tooth blade mounted backwards is what I remember. LOUD and hearing protection was for woosies at the time. Huh? What? :huh:
RE: Cutting Steel siding on a Morton building - Tim in Indiana - 07-19-2016
Use a set of snips, I normally use a 12" set. Just like large scissors and you can buy them at Home Depot, Menard, etc. Shouldn't set you back more than $25 for a good American made set.
I have cut hundreds of feet of steel ribbed siding. Most steel is delivered to the jobsite cut to length but gable ends we cut on site. It only takes 30 seconds to cut across the width. Rip cuts we use a three blade electric shear.
RE: Cutting Steel siding on a Morton building - Stwood_ - 07-19-2016
I use a 4" grinder with a 1/16" thick cutoff wheel.
Shears are a pain to use.
Safety glasses, ear plugs