Electrical questions. - Printable Version +- Woodnet Forums (https://forums.woodnet.net) +-- Thread: Electrical questions. (/showthread.php?tid=7326894) Pages:
1
2
|
RE: Electrical questions. - JTTHECLOCKMAN - 01-12-2017 Don't forget the cabon monoxide detectors also. A must in any code situation city or rural. RE: Electrical questions. - daddo - 01-12-2017 I got started and set a new indoor panel. The smallest I could find was a 125 amp. I need to run a new service wire to it to update the separate ground/neutral. What size wire is required from the main? I finally got with the co-op on the loop and main outside- he's coming tomorrow to explain the process and their requirements. It's hard to believe this house has been running fine for 30 years on a 30 amp breaker. No wonder the elect bills are around 45- 75 bucks. I do have it well insulated. RE: Electrical questions. - TDKPE - 01-13-2017 (01-12-2017, 11:38 PM)daddo Wrote: I got started and set a new indoor panel. The smallest I could find was a 125 amp. I need to run a new service wire to it to update the separate ground/neutral. What size wire is required from the main?Is there an outside panel also? Service conductors for 125A can be 2-gauge copper or 1/0 aluminium [Table 310-15(b)(6)]. But if there's an outside panel with breakers or fuses for some of the loads, splitting off to another (inside) panel, you'd have to upsize them to 1/0 copper or 3/0 aluminium, using the 60C column, since the load diversity taken into account in the main service conductors is not fully present [Table 310-16]. Pulling separate conductors in conduit would allow 1-gauge copper or 2/0 aluminium. RE: Electrical questions. - daddo - 01-13-2017 It's just for the indoor panel. I have more than enough aluminum XHHW-2, 3 core w/ground wire here. RE: Electrical questions. - rwe2156 - 01-17-2017 I know you've already started but I STRONGLY suggest you consult an electrician. In my area and most I know of, the power company will not upgrade a service supply without a licensed electrician and a permit. In the end you might not be saving as much as you think. From experience, I can tell you electricians can buy wire, panels, etc for 1/2 what you would pay. If finances permit, spending a few thou to rewire the house is a worthwhile investment especially if you ever decide to sell it. Even if you needed a home equity loan to do it, I would go for a rewire and upgrades service to at least 150A. |