+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Holding small tenons (/showthread.php?tid=7335030)
Pages:
1
2
RE: Holding small tenons - hairy - 11-29-2017
(11-25-2017, 01:36 PM)Bill Mains Wrote: Making ornaments with small urchin shells. Want to turn tenon first n drill small hole then reverse it to hold the tenon to finish turning the finial. Pin jaws too large and don't want to buy anything. Thought I saw where someone made a type of compression chuck out of wood to hold small tenon~ any suggestions?
I have a harbor fright drill chuck, 1/2" MT2. It wasn't set up to use as a drawbar when I bought it. All it takes is a drill and tap and some hardware.
RE: Holding small tenons - Dusty Workshop - 11-29-2017
Another good solution rhat there!