Bevel Rip Fence for the Band Saw - Printable Version +- Woodnet Forums (https://forums.woodnet.net) +-- Thread: Bevel Rip Fence for the Band Saw (/showthread.php?tid=7344618) Pages:
1
2
|
RE: Bevel Rip Fence for the Band Saw - jlanciani - 11-28-2018 Just for the record, you can get clear PVC primer. The purple just makes it easier for the plumbing inspectors... RE: Bevel Rip Fence for the Band Saw - AgGEM - 11-28-2018 (11-28-2018, 01:21 PM)jlanciani Wrote: Just for the record, you can get clear PVC primer. The purple just makes it easier for the plumbing inspectors... I know....I am the Charlie Brown pen / pencil pal of purple plastic plumbing primer.....phooey... RE: Bevel Rip Fence for the Band Saw - Stwood_ - 11-28-2018 So your factory 4" dc outlet doesn't work well?? I have a MM16, almost identical saw. I use the factory port with no problems. RE: Bevel Rip Fence for the Band Saw - AgGEM - 11-29-2018 (11-28-2018, 11:55 PM)Stwood_ Wrote: So your factory 4" dc outlet doesn't work well?? I use a shop vac pulling though a Dust Deputy. I do notice an improvement with the Cosman approach. By how much would be guess work. RE: Bevel Rip Fence for the Band Saw - Stwood_ - 11-29-2018 Ok. Have you had a dust collector hooked to it before? RE: Bevel Rip Fence for the Band Saw - AgGEM - 11-29-2018 (11-29-2018, 10:00 AM)Stwood_ Wrote: Ok. Have you had a dust collector hooked to it before? No on a dust collector / 4" plumbing. Yes, Shop vac through the OEM 4" port. Only the top port. RE: Bevel Rip Fence for the Band Saw - Alan S - 11-30-2018 One option is to use a soda bottle as the end of the duct under the table. It can deform or even get cut when you tilt the table without a real problem, though it does sound horrendous as the blade cuts it. To make tilting the blade quick and accurate, your saw may have the bolt used as a stop under the table. With the Delta style, you can make a series of bolts to swap out; when you adjust the tilt you simply loosen trunnions, put in the stop for the angle you want, push the table down to the stop and tighten the trunnions. I think this approach was described in John White's "Care and repair of shop machines". RE: Bevel Rip Fence for the Band Saw - AgGEM - 12-24-2018 (11-29-2018, 02:59 AM)AgGEM Wrote: I use a shop vac pulling though a Dust Deputy. Update: Bevel fence jig is almost finished, first test cut looks promising. Will post photos when the jig is more functional. I had my first look inside the lower housing, after a month with the new Cosman DC setup. I can report significant improvement in dust collection with his plumbing method. There was very little dust to be found. |