+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: More work to do (/showthread.php?tid=7349707)
Pages:
1
2
RE: More work to do - bandit571 - 08-23-2019
All polished up....high tech polisher
[attachment=20141]
Then a second coat, rubbed down with a rag....
[attachment=20142]
other side got the same treatment....
[attachment=20143]
And a test drive was done..about 10 strokes..
[attachment=20144]
Saw is about as done as I will do, today...saw set?
[attachment=20145]
Right now, the number on the anvil reads "8"..
[attachment=20146]
Millers Falls No. 214....might work on the 7ppi saw teeth?
Stay tuned
RE: More work to do - bandit571 - 08-24-2019
We have more work to do...until I find enough lumber for a project to build...
so...a few block planes need some work.. [attachment=20169]
5 planes....counting the two from this year's sales...
[attachment=20170]
Some parts were cleaned up, threads oiled, others got a new coat of paint...decided to at least get the red one done...
[attachment=20171]
Sole is flat as I need it to be. iron got it's back flattened, bevel sharpened to 25 degrees, honed to 2,000 grit, then stropped...put the plane back together
[attachment=20172]
Once I got the iron adjusted for depth and lateral,
and the test track grain going the right way took it for a test drive.. [attachment=20173]
Plane was sold by Geo. Worthington Co. of Cleveland, OH....marked on the iron as a W2200. Seems to be a Stanley No. 220.
As for the rest of the mob..
[attachment=20174]
May do one a day? The bad one is the ..
[attachment=20175]
The Great Neck knock-off of a Stanley # 9-1/2...sole will need a LOT of work..
[attachment=20176]
Ummmmm. Will update as I go along....
Stay tuned
RE: More work to do - bandit571 - 08-25-2019
Will be throwing one of the irons away....paper thin, stamp just says "JAPAN"....even the honing guide makes it bend.....sounds like a little bird."Cheep, cheep..cheap"
I think I might have a spare iron, or three. Of the next 3 to work on...the 220 look alike MIGHT be a Millers Falls version....since the iron has that triangle logo.
Stay tuned....will see what is going on, after Lunch.....