Lie-Nielsen Honing guide and Off-brand tools? - Printable Version +- Woodnet Forums (https://forums.woodnet.net) +-- Thread: Lie-Nielsen Honing guide and Off-brand tools? (/showthread.php?tid=7353007) Pages:
1
2
|
RE: Lie-Nielsen Honing guide and Off-brand tools? - Admiral - 02-20-2020 (02-20-2020, 09:43 AM)hbmcc Wrote: My worry is the two are so similar that the smaller chisels I can't control freehand, due to incompatibility with the E-type, will still share the same problems on the LN. I don't know what kind of smaller chisels you are thinking about, but the shorter butt chisels often won't register in the ecplise, which is why I keep a General knockoff of the Stanley 200 hanging around. One recently sold here: https://forums.woodnet.net/showthread.php?tid=7346020 Here's a 2 1/2" blade length butt chisel in mine: RE: Lie-Nielsen Honing guide and Off-brand tools? - mike4244 - 02-21-2020 (02-18-2020, 04:05 PM)Philip1231 Wrote: I have been using the LN guide for years and it has proven to be an excellent addition to my sharpening arsenal. I have a couple of honing guides but haven't used them for years. I generally hone freehand. Small chisels under 1/2" wide I use a wood wedge jig I made when I was young. I cut the wedge to angle needed, 25° I think. Then plow out 3 areas 1/8" / 3/16" / and a 1/4" wide and about 1/4" deep. maybe 1-1/2" long. The total length is about 4" long and 1/2" deep x 2" wide rabbet removed for the handles. Dimensions are approximate since I am not in the shop right now. The sharp end of he wedge is cut off to 3/16" or so. I install a chisel, slide down til it hits the stone. Then hone the bevel. The rabbet keeps the chisel at a constant angle. I do not bother with secondary bevels so 25° works for most chisels. mike RE: Lie-Nielsen Honing guide and Off-brand tools? - hbmcc - 02-22-2020 (02-21-2020, 07:44 PM)mike4244 Wrote: I have a couple of honing guides but haven't used them for years. I generally hone freehand. Small chisels under 1/2" wide I use a wood wedge jig I made when I was young. I cut the wedge to angle needed, 25° I think. Then plow out 3 areas 1/8" / 3/16" / and a 1/4" wide and about 1/4" deep. maybe 1-1/2" long. The total length is about 4" long and 1/2" deep x 2" wide rabbet removed for the handles. Dimensions are approximate since I am not in the shop right now. I think I picture the description you wrote. If correct, you could work three tools at one time. Do you have a sled it rides on to avoid abrasion from the stones? |