+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Router or Rasp? (/showthread.php?tid=7358005)
Pages:
1
2
RE: Router or Rasp? - D_Harris - 10-11-2020
(10-03-2020, 01:49 PM)handi Wrote: This was exactly what I was thinking.
But shouldn't I use a 3/4" Radius Round Over Bowl Bit? (The one in that link has a 1/2" radius).
Now, I see a lot of 3/4" round-over bits on the internet, but the angles are not mentioned. (That 10° angle is important).
Outside of that, I do have block planes and just need to pick up sanding blocks.
Thanks.
Darren Harris
Staten Island, New York.