"we have a Plan" - Printable Version +- Woodnet Forums (https://forums.woodnet.net) +-- Thread: "we have a Plan" (/showthread.php?tid=7376746) Pages:
1
2
|
RE: "we have a Plan" - bandit571 - 09-12-2024 Page #3... [attachment=52492] Worked of a few rips... [attachment=52493] To get rid of the barky parts.. [attachment=52494] To get 2 center stile blanks [attachment=52495] Jigged up to run a few beads.. [attachment=52496] One per edge... [attachment=52497] Cross cut and rip for 3 rails.. [attachment=52498] Top, bottom and middle rails....which also need beads run [attachment=52499] Regardless of grain direction....a sharp #23 bead cutter will still do the jobs... Still to do? [attachment=52500] Need to run a bead along both edges of the outside stiles...maybe later today? Then, maybe start on a bit of joinery? [attachment=52501] Mitered Half Laps..... Stay tuned... RE: "we have a Plan" - bandit571 - 09-17-2024 Will up-date this thread, later this evening....have a bit of work to do, today.. [attachment=52527] This was at quitting time , yesterday afternoon...on a Monday, no less... [attachment=52528] Was a rather busy 90 minutes, at that.. Stay tuned...film @2300 hrs... RE: "we have a Plan" - bandit571 - 09-18-2024 The Long Stiles: corner joint is a mitered half lap... Find the angle.. [attachment=52537] Marking gauge to lay out the cuts.. [attachment=52538] MitreBox & Saw to make a stopped cut... [attachment=52539] Then a rip cut... [attachment=52540] Then a wide chisel to level and clean up.. [attachment=52541] Need 2 stiles done, for now.. [attachment=52542] Saved one of the cut-offs....need it to set the 27 degree cut that this needs.. [attachment=52543] Set it to the saw.. [attachment=52544] Only going 1/2 way down...then a big old rip saw to remove the waste.. [attachment=52545] Again, wide chisel to clean and level..until it matches the stile's corner.. [attachment=52546] Repeat 3 more times... Stay tuned.. |