+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: 3D Chessboard - progress picks (/showthread.php?tid=7376972)
Pages:
1
2
RE: 3D Chessboard - progress picks - BrokenOlMarine - 10-19-2024
(10-18-2024, 09:54 AM)Dumb_Polack Wrote: Yes it is. There's a groove there that the board sits on. Also on the bottom I glued on a 1/4 piece of plywood. Then the whole thing got glued into the cherry base. There's also a maple spline in each corner.
If you look at the bottom RH picture and the bottom RH corner, you might see that that corner didn't close up 100%. Bothers me a little.
If you read my knife display post, you'll see that the shop gremlin opened a couple corners during my six week build as well. One was bad enough I cut a thin sliver from a scrap left over and filled that gap. The others, I chose to ignore. We will see them. Ninety eight percent will see the beauty of your project.
I haven't played chess in decades, but I'll always stop in to admire beautiful woodwork. Well done.