(02-18-2025, 10:16 PM)GaryMc Wrote: Well, this morning I did the glue-ups using System 3 T-88 as recommended.  Two assemblies so 20 joints total, all done with the same mix.  Couple things - shop temp was about 55 F so both parts and even the mix were very viscous and difficult to pour and apply.  Next time I will warm things up!  Also (uncertain about how much would be needed), I mixed up about 3 times too much.

This afternoon after about 6 hours, I noticed the glue was still somewhat sticky, both the squeeze-out and the leftover amount, probably a temperature thing again.  Couple hours later it was nearly solid.  I intend to leave it in clamps for more than a day to make sure.

I found the vinegar tended to just smear the squeeze-out when wet, so gave up on that and hope it works better when set.  While tacky, I did remove most of it with a chisel.