+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Planing dovetails? (/showthread.php?tid=7333713)
RE: Planing dovetails? - Tony Z - 10-06-2017
(10-04-2017, 12:55 AM)Derek Cohen Wrote: No Bruce ... just a bad joke. I was surprised, though, to see him belt sand his dovetails in the recent FWW video. I struggle to imagine how that will avoid rounding over the edges.
I always plane inwards. I used to work with a sharp, low angle jack plane. Now I like the LV Custom #7 Jointer as this has a 40 degree bed, can be set up with a closed chip breaker, and will plane into grain.
Regards from Perth
Derek
Derek, how have you been?
Anyhow, I also seem to recall a PWW or PWW article where he also used a belt sander to "level off" inset drawers. More power to anyone with sufficient muscular control to be able to perform such a task!
RE: Planing dovetails? - ranger29 - 10-06-2017
(10-03-2017, 11:19 AM)Derek Cohen Wrote: Just two words ....
belt
sander
.... if Becksvoort does so, why argue?
Regards from Perth
Derek
+1
RE: Planing dovetails? - AHill - 10-06-2017
I find it ironic that a belt sander would be suggested in a hand tool forum. That said, more power (pun intended) to those who have enough control to be able to use a belt sander without destroying your drawer in the process. Using a belt sander for somewhat delicate work if you're not practiced or without the proper skills is an invitation to disaster. I could maybe see taking the drawer to a stationary belt sander. I just don't think it's wise to take a portable belt sander to a drawer than you've invested a fair amount of time with hand cut dovetails, only to risk taking off too much material, rounding over corners, and whatever else might happen with unskilled use of a portable belt sander.
RE: Planing dovetails? - Derek Cohen - 10-07-2017
(10-06-2017, 10:34 AM)Tony Z Wrote: Derek, how have you been?
Anyhow, I also seem to recall a PWW or PWW article where he also used a belt sander to "level off" inset drawers. More power to anyone with sufficient muscular control to be able to perform such a task!
Good Tony, thanks. It's been a busy year.
Any more daughters to marry off (I have a son of 24 ...)?
Regards from Perth
Derek
RE: Planing dovetails? - Tony Z - 10-07-2017
(10-07-2017, 06:49 AM)Derek Cohen Wrote: Good Tony, thanks. It's been a busy year.
Any more daughters to marry off (I have a son of 24 ...)?
Regards from Perth
Derek
Two married off, one to go, but she's only 17, and has lots of school ahead!
Four grand babies-2 boys, each three and 2 girls, each one. One of my grandsons spent several hours with me (along with my son-in-law) in the shop this morning. I don't know which is the bigger novice! Now, for last year's Christmas, I built each older girl a work bench, saw horses, Roy Underhill style tool tote, complete with basic handtools (both older girls are quite handy).