+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Camber or straight? (/showthread.php?tid=7343526)
RE: Camber or straight? - Handplanesandmore - 10-10-2018
(10-10-2018, 11:02 PM)adamcherubini Wrote: One more than thing. I’ve glued up many edge joints prepared with my try plane. If the edge has a tiny hollow, that’s okay.
If you want to use your try plane for edge joints with PVA, that’s ok. But use a bunch of clamps and tighten them down pretty hard.
Again, I hope this helps
Not sure if you're talking about a spring joint by your term of a hollow edge. Or, you are referring to a hollow left by the camber blade across the edge. If the former, a spring joint reduces the no. of clamps needed for the edge glue-up.
Simon
RE: Camber or straight? - CStan - 10-14-2018
Straight enough so that the lightest shaving you intend to take with the plane will still be 3/4's (++) the width of the iron on a board that's pretty flat. No bench plane should ever really be cutting with just its nose, a shaving only a half inch wide or less, unless you are just starting to surface a board and it's still very rough.
For a jointer plane iron, this implies a curvature that is almost imperceptible to the eye, you have to hold it up to a straight edge to "see" the curvature.