+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: PSA -- connecting stovepipe together (/showthread.php?tid=7345997)
RE: PSA -- connecting stovepipe together - Edwin Hackleman - 01-30-2019
(01-30-2019, 04:26 PM)daddo Wrote: I drill first hole then- pi x diameter divided by 2, measure center from hole to hole and drill. If you're worried about being straight, use a piece of tape wrapped around the pipe, but I never had trouble with that.
(1) How did you measure the outside diameter? And, was the stove pipe perfectly round?
(2) How did you make sure that the tape was wrapped straight around the pipe with no slant?
(3) How did you measure the length of the tape that you wrapped, before or after you wrapped it?
Just curious.
RE: PSA -- connecting stovepipe together - Wild Turkey - 01-30-2019
(01-30-2019, 08:02 PM)Edwin Hackleman Wrote: (1) How did you measure the outside diameter? And, was the stove pipe perfectly round?
(2) How did you make sure that the tape was wrapped straight around the pipe with no slant?
(3) How did you measure the length of the tape that you wrapped, before or after you wrapped it?
Just curious.
Old welders trick.
Use paper that's heavy and wide enough not to flex.
Wrap the pipe and mark where it starts to overlap.
Lay flat and then you can easily measure total length and subdivide as needed.
Use wide enough piece you can measure a square the length of the pipe diameter, fold corner to corner both ways, then cut along the top two creases and you can lay out a 45 degree joint.
Before calculators and computers we used pencils and paper to solve problems
RE: PSA -- connecting stovepipe together - MarkSingleton - 01-31-2019
(01-30-2019, 10:28 PM)Wild Turkey Wrote: Before calculators and computers we used pencils and paper to solve problems
In other words using your brain!!!