+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Pitch Removal (/showthread.php?tid=7350663)
RE: Pitch Removal - cams2705 - 10-09-2019
(10-09-2019, 07:55 AM)Derek Cohen Wrote: Soak in Simple Green, scrub with an old tooth brush, then rinse off with Hot water. Dry with a hair dryer or hot air gun. Should take 5 minutes.
Regards from Perth
Derek
+1 on the simple green. I bought a gallon, an oil change pan, and a brass brush to clean all blades and bits. When I'm done, I pour it right back into the gallon. Been reusing it for the past 5-6 years.
RE: Pitch Removal - MidwestMan - 10-09-2019
Thank you all. Far more information than I expected. Howards input was always excellent, and worth listening to. I see he hasn't posted in over three years, that's too bad.
RE: Pitch Removal - Cooler - 10-10-2019
Denture cleaners will remove organic matter safely.
Place the saw blade in a shallow dish filled with very hot water and drop 4 or more tablets in the water and wait about 10 minutes (or until the solution clears). Wash and then add some WD40 as the super clean surface will corrode quickly.