+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Resawing on bandsaw (/showthread.php?tid=7365898)
RE: Resawing on bandsaw - jteneyck - 11-14-2021
The Grizzly cast iron fence is quite rigid and the locking mechanism is very good, too, but I'm really only using it with my tall fence to keep it parallel with the miter slot. Any fence would work though you might have to clamp the tall fence at both the front and back.
John
RE: Resawing on bandsaw - Bill Holt - 11-14-2021
Tapper, I went to a lot of trouble to get the perfect fence...not!!! I simply clamped a board to the table. I was resawing 8" cedar and I may not be so lucky in hardwood but I will not hesitate to try the idea again.
RE: Resawing on bandsaw - jteneyck - 11-14-2021
Curious, I just realized the OP never made another comment. Did we scare him/her off?
John