+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: How to polish a saw plate (/showthread.php?tid=6366663)
Re: How to polish a saw plate - MarvW - 05-14-2013
Toby,
Not just any green...............John Deere Green!!
Re: How to polish a saw plate - Steve Friedman - 05-14-2013
MarvW said:
Not just any green...............John Deere Green!!
Can't believe how much mileage you've gotten out of painting one handle!
Marv's post reminded me of a caution. As I was using Christian's technique to shine a few saw plates last night, I forgot that some of them had just come back from Marv. I guess I got too close to the teeth because suddenly the saw was covered with more blood than Autosol. I think it just adds some flavor.
Steve
Re: How to polish a saw plate - Dammittim - 05-14-2013
My High School Shop class had one rule " Don't Bleed on the Tools, it will make them rust" Per Mr. Hienz and Mr. Lentz.
Tim
Re: How to polish a saw plate - rhino - 05-14-2013
I was pondering a saw at a flea market a few weeks ago and it slipped every so slightly from my hand. I reached out with my left hand to stabilize it, and left quite a bit of my flesh on the teeth. Given that it could have been viewed as a biohazard, I had to buy the saw. I offered him a bloody dollar bill, which he accepted provided that I leave and clean up my hand
Lesson here is that sometimes(and I mean rarely) blood on a saw (in this case a D-8) can lead to a good deal.
Re: How to polish a saw plate - MarvW - 05-14-2013
Steve,
Toby made me do it....
Re: How to polish a saw plate - TobyC - 05-14-2013
Hey Marv,
Why are the slots on the left side?
You may have been asked this before...humor me.
Toby
Re: How to polish a saw plate - MarvW - 05-14-2013
Toby,
What slots?
Re: How to polish a saw plate - Joe Bailey - 05-14-2013
Marv - I believe Toby is referring to the fact that it looks like the screw slots are showing on the same side as the medallion in your photo.
Re: How to polish a saw plate - TobyC - 05-14-2013
MarvW said:
Toby,
What slots?
Screw slots. (Actually it's the nuts.)
Re: How to polish a saw plate - mbole - 05-15-2013
I just give a shot to Aluminium foil-polish combination, and it look nice.
I also did another side of saw with same polish (festool 6000 grit) and medium hard felt pad on festo rotex.
I can't see the difference.
Is there any reason why not to use power polisher?