+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Chainsaw and bowl blank prep (/showthread.php?tid=6855353)
Chainsaw and bowl blank prep - robo hippy - 10-14-2014
Another clip from me, and will have one up on bandsaws soon.
https://www.youtube.com/watch?v=F3s6aN9REIY
robo hippy
Re: Chainsaw and bowl blank prep - Bob Atchison - 10-14-2014
Informative. Thanks.
Re: Chainsaw and bowl blank prep - coachmancuso - 10-14-2014
Great video ! Everyone should see this even if they have been cutting blanks for a while, it was good!
Re: Chainsaw and bowl blank prep - Steve K - 10-14-2014
Thank You!
Re: Chainsaw and bowl blank prep - Dennis Puskar - 10-14-2014
Very good video.
Thanks
Re: Chainsaw and bowl blank prep - David Delo - 10-14-2014
Robo,
You sportin those new see-through chaps????? ha ha!!!!
Nice video, thanks for making it and sharing.
Re: Chainsaw and bowl blank prep - MichaelMouse - 10-15-2014
Wind Shakes (ring shakes) refer to separation between annual rings. Heart checks radiate from the juvenile wood at the heart.
Wind shakes should be considered a fatal flaw, because there is no assurance that glue will hold them together as you turn. Eastern hemlock, shown here, is (in)famous for wind shakes.
Those trying for maximum capacity over the bed can use their bandsaw to remove the little corners that might catch on their lathe. With the chainsaw undercut method, they can even do it for blanks thicker than the depth capacity of their saw. Over the bed doesn't make any difference to you guys with the huge iron, though.
Re: Chainsaw and bowl blank prep - badwhiskey - 10-15-2014
Very informative.
Re: Chainsaw and bowl blank prep - robo hippy - 10-15-2014
Dang MM, maybe we agree here for once. I didn't pick up that I called it ring shake till after it was edited. The picture you show is an excellent example of ring shake. I do think wind shake is different, but just about every log I have ever cut up has some checking off the pith.
robo hippy
Re: Chainsaw and bowl blank prep - MichaelMouse - 10-15-2014
Well, anyone COULD look it up.
http://forestry.about.com/od/foresthealth/ss/Ring-Shake-And-Wind-Shake.htm
Always helps to speak the same language if you're looking to communicate. Even if the wind doesn't cause wind shake. Imagine that hemlock being troubled by the wind when it's set around with spruce and a foot and a half at the base?
Heart checks are part of the maturing process. Heartwood is always dryer than sapwood - a LOT dryer if you look at the sapwood checks on the piece you're cutting in the clip. It opens up a bit as it contracts. I personally think neglected heart checks account for a lot of new turners' frustration with green wood. That, and broad bottoms.