+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Finally making some progress on my workbench. (/showthread.php?tid=6903197)
Finally making some progress on my workbench. - lincmercguy - 12-15-2014
Decided to start sawing during the Thanksgiving break. I've been planning this one for a while. I had planned to use the sandply stuff from the Home Depot, but that stuff really looked like crap this time around. I couldn't believe it. It was usually pretty decent. I ended up getting their maple plywood for about $10/sheet cheaper. It's definitely not the best stuff, but if it's good enough for the pantry, it's good enough for a workbench.
I was able to make good use of my old workbench. I sure didn't want to just cut it up. I stuck some harbor freight wheels on it and took it to the farm for a shop workbench (most of the shop is dirt floor).
Re: Finally making some progress on my workbench. - lincmercguy - 12-15-2014
This is what I'm building, or at least attempting to. All of the openings will be drawers of various heights.
Re: Finally making some progress on my workbench. - titanxt - 12-15-2014
LincMercGuy,
Nice progress for sure! But you are a lot smaller than I thought you would be...
Andy
Re: Finally making some progress on my workbench. - lincmercguy - 12-15-2014
It's a really big bench. Those are 240V 40A outlets in the front.
Re: Finally making some progress on my workbench. - Martin S. - 11-18-2015
Did you get this finished?
I might have missed it in another thread.
Re: Finally making some progress on my workbench. - Scott W - 11-18-2015
What is he holding? Slingshot?