+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Thinnest TS Blade (/showthread.php?tid=7106942)
Pages:
1
2
Thinnest TS Blade - Shovel Man - 09-28-2015
I want to rip some expensive wood into thin strips and want to minimize waste. A thin blade that makes a smooth cut would be best. It could be smaller diameter since it will only need to cut thin material. There should be a lot of selection at reasonable cost at 7 1/4". What do you recommend?
Re: Thinnest TS Blade - KC - 09-28-2015
is the arbor hole the same size? I've never paid attention...
Re: Thinnest TS Blade - Mac1 - 09-28-2015
This one looks pretty thin.
http://www.amazon.com/Freud-D0740X-Finis...1979&sr=8-3
Re: Thinnest TS Blade - Howard Acheson - 09-28-2015
A bandsaw blade will cut with a smaller kerf than any table saw blade. But, a band-saw blade will leave a less smooth surface. By the time you smooth the surface, you may end up with more sawdust.
Trying to rip thin wood can be dangerous.
Re: Thinnest TS Blade - jteneyck - 09-28-2015
I've used the 7-1/4" Diablo TK ripping blade in my TS with no issues. It takes a very narrow kerf and leaves a smooth edge. I bought it at HD for around $10 which makes it a genuine bargain. They also make a finishing blade, which might work even better if you are cutting thin stock. In any case, use a ZCI with it and you should have no trouble ripping your thin strips.
John
Re: Thinnest TS Blade - Mr Eddie - 09-28-2015
+1
I ripped some 3/4" stock yesterday with a Freud 7 1/4" blade and it worked fine.
Re: Thinnest TS Blade - Splinter Puller - 09-28-2015
i often use doubled & spaced 7-1/4" blades on my tablesaw to cut perfect thickness tenons for large production runs. never had a problem.
Re: Thinnest TS Blade - Brian in sunny FL - 09-28-2015
This is the thinnest I've seen in a 10" blade. Scroll down a little to see the 10".
http://www.totalsawsolutions.com/index.htm
Re: Thinnest TS Blade - BloomingtonMike - 09-28-2015
You might have luck at stewmac with a fret saw blade
.060 thick. .023 wide slot, 6" dia
http://www.stewmac.com/Luthier_Tools/Types_of_Tools/Saws/Fret_Slotting_Table_Saw_Blade.html
Re: Thinnest TS Blade - knotscott - 09-28-2015
Total Solutions and Infinity both make an excellent 10" ultra thin kerf 40T general purpose blade that cut extremely well. The kerf is about 1/16".