+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Suggest a new load disconnect switch (/showthread.php?tid=7126273)
Suggest a new load disconnect switch - atgcpaul - 10-23-2015
This 40A switch needs to be replaced but I'm having trouble finding something comparable. It sits on a DIN rail. Any suggestions?
Thanks,
Paul
Re: Suggest a new load disconnect switch - GHR - 10-23-2015
I would suggest using google with the manufacturer and number that is visible on the top of the switch.
http://www.socomec.com/range-load-break-...mp;view=picture
http://www.directindustry.com/prod/socomec/product-8152-98832.html#product-item_1291983
Re: Suggest a new load disconnect switch - atgcpaul - 10-23-2015
GHR said:
I would suggest using google with the manufacturer and number that is visible on the top of the switch.
http://www.socomec.com/range-load-break-...mp;view=picture
http://www.directindustry.com/prod/socomec/product-8152-98832.html#product-item_1291983
Should have been more clear. Looking for something more readily available--like Monday. I need to go through their US distributor--they have one office in the US and noone picked up this afternoon. Trying to find an alternative. Grainger sells a Square D but it's only 3 pole.
Re: Suggest a new load disconnect switch - EricU - 10-24-2015
I usually go to Automation Direct for stuff like that. I think I have this disconnect on my mill disconnect
Re: Suggest a new load disconnect switch - atgcpaul - 10-29-2015
GHR said:
I would suggest using google with the manufacturer and number that is visible on the top of the switch.
http://www.socomec.com/range-load-break-...mp;view=picture
EricU said:
I usually go to Automation Direct for stuff like that. I think I have this disconnect on my mill disconnect
You were both right. I contacted the US sales office and after some back and forth, they said the easiest place to buy it was Automation Direct. After I slapped myself on the forehead for not searching for "Socomec" on Automation Direct, I ordered it and replaced the disconnect today. All better now.
Thanks to both.
Paul