+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: ISO Keyless 1/2' #2MT chuck/drawbar (/showthread.php?tid=7126874)
ISO Keyless 1/2' #2MT chuck/drawbar - craneman54 - 10-24-2015
I just spent an hour looking on the internet and can't find this thing. I know they exist,but they are better at hiding than I am at looking.
Any help would be great.
Re: ISO Keyless 1/2' #2MT chuck/drawbar - NCPaladin - 10-24-2015
You may have to buy them separate. Here is a 2MT with 1/2X20 tpi that accepts a 3/8" drawbar.
About half way down ...
http://www.victornet.com/report/Arbors-Morse-Taper-Straight-Shank-to-Threaded-End/1424.html
Most 1/2" drill chucks accept a 1/2 X 20 tpi, a few may take a 3/8 instead.
Here is just one that takes a 1/2-20 tpi mount.
http://www.amazon.com/Jacobs-31051-SoftG...2+keyless+chuck
Re: ISO Keyless 1/2' #2MT chuck/drawbar - craneman54 - 10-24-2015
Thanks for the help.
It may cost a little more for shipping, but at least I will get what I need.
Re: ISO Keyless 1/2' #2MT chuck/drawbar - iclark - 10-24-2015
I did a google using
"keyless chuck" "draw bar"
and got a lot of 1/2" chucks including PennState and Packard Woodworks.
Apparently, the Woodriver 2MT keyless chuck used to be set up for a draw bar, but no longer is.
I think that Best Wood Tools used to have some, too, but they do not seem to carry them now.
Re: ISO Keyless 1/2' #2MT chuck/drawbar - craneman54 - 10-25-2015
Thanks for the help guys.
I ordered the Pennstate one plus there version of a 5/8 steb center.
Re: ISO Keyless 1/2' #2MT chuck/drawbar - Arlin Eastman - 10-25-2015
I am not picturing what you will use it for unless it is for a drill head?
Arlin
Re: ISO Keyless 1/2' #2MT chuck/drawbar - craneman54 - 10-26-2015
Arlin I want to cut threads in wood/
This will show you what I want to do.
Thread cutting