Who to ask to fix smoking compressor motor? - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Who to ask to fix smoking compressor motor? (/showthread.php?tid=7140100) |
Who to ask to fix smoking compressor motor? - mikefm101 - 11-10-2015 Hi, I have a Crafstman air compressor given to me as a gift a number of year ago. It is pretty small, weighs maybe 15 lbs, but for the infrequent use it is fine for me. I use the compressor just a few times each year for finish nails or staples. Recently the motor began smoking when I turn it on and would like to see if it can be repaired before I replace it. I am not exactly sure what kind of repair place to search for to do this, though. I don't think "small engine repair" is right as that is mostly lawnmowers. What kind of company to call for this? Thanks....Mike Re: Who to ask to fix smoking compressor motor? - fredhargis - 11-10-2015 A motor shop (search electric motor repair). To be honest, I'd look for a replacement first to get an idea of the cost before having that one diagnosed. The minimum charge may equal what a replacement would cost, and once the magic smoke gets released it can get pretty expensive to have it put back in. Re: Who to ask to fix smoking compressor motor? - TDKPE - 11-10-2015 What he said, right up there, next floor. ^^^^^^^^^^^^^^^^^^^^^^^^^ A motor repair shop will probably say a) throw it away and buy a new compressor, followed by b) that'll be $60. Cash, check, or credit card. Those little motors aren't designed to be serviced. There is an off-chance that it's easily fixed, but it's far off. Once they start smoking, it usually means the winding insulation is burning, and that requires rewinding. And I doubt they even have winding data for it. But even if they did, it would cost more than a new compressor. You might get lucky if you crack open the housing and can find a number on the motor and find a replacement, but that's as far as I'd take it. If that far. Re: Who to ask to fix smoking compressor motor? - BloomingtonMike - 11-10-2015 Id check the motor for a faceplate and frame. Check rpm and fla. Verify length and diameter of motor shaft. Get on ebay and replace it. Re: Who to ask to fix smoking compressor motor? - Chris S - 11-10-2015 If you haven't already, give the entire compressor a thorough clean out with some compressed air. It could just be some debris caught between working surfaces inside the unit. |