A mini-hammer for a mini purpose - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: A mini-hammer for a mini purpose (/showthread.php?tid=7148010) |
A mini-hammer for a mini purpose - Rich's Woodcraft - 11-20-2015 I like to make miniatures of some of my projects, usually ahead of time to work out scale and proportion. In this case I decided to make a one-third scale version of my popular plane hammer. I have a few mini tools and thought this would be a nice addition to the set. The hammer is 4 inches long, the head is brass, turned from a piece of 1/4" brass rod. The handle and wooden face are bubinga and the wedge in the handle is maple. Here it is adjusting my Veritas mini shoulder plane. This was turned on my Delta midi lathe and as most of you know, took longer than the full scale version to make. Enjoy! Richard Re: A mini-hammer for a mini purpose - chips ahoy - 11-20-2015 Well done Rich, nice job. Gonna be down your way Thursday, have to make a stop at Hfx Specialty Hardwood, among other stops. Mel Re: A mini-hammer for a mini purpose - Rich's Woodcraft - 11-20-2015 Thanks Mel, Say hi to Cheryl for me!! Re: A mini-hammer for a mini purpose - BaileyNo5 - 11-20-2015 Hi Rich It looks very nice. How did you attach the bubinga face to the brass? And hey, we need a bigger picture - we can't see all the fine detail! Re: A mini-hammer for a mini purpose - Rich's Woodcraft - 11-20-2015 I don't have a real tight shot, here's a higher res version of it on the tool box I made for it. On the full size hammer, the wooden face is attached by a threaded tenon. On the mini, I just turned a 3/32" tenon and drilled the wooden face to CA it on. Re: A mini-hammer for a mini purpose - chips ahoy - 11-20-2015 Rich Forgot to mention, since you are using the Delta I could bring my trailer and take that Oneway off your hands. Mel Re: A mini-hammer for a mini purpose - Rich's Woodcraft - 11-20-2015 sure Mel, Bring a few large friends by on Thursday and mule it out... :-) Stay tuned for my next blog post tomorrow Re: A mini-hammer for a mini purpose - chips ahoy - 11-20-2015 Rich I know it would take many large friends. It is my dream lathe. I have a General International with EVS that I really like. Mel |