Lingerie Chest: Designing the Drawers - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Lingerie Chest: Designing the Drawers (/showthread.php?tid=7149646) |
Lingerie Chest: Designing the Drawers - Derek Cohen - 11-22-2015 This is the start of the second stage in this build. Now that the carcase and drawer blades/runners are completed, it is time to start on the drawers. The drawers are complex as they call for compound angles and dovetails. The design may be improved, and I welcome comments about this and the methodology. This chapter provides a pictorial on the design and construction I have come up with so far. Pine is used in this test case (where Jarrah fronts and Tasmanian Oak sides will be used in the final build). However, the construction is for real. The link is here (too many photos to post on the forum): http://www.inthewoodshop.com/Furniture/DesigningTheDrawers.html Regards from Perth Derek Re: Lingerie Chest: Designing the Drawers - hbmcc - 11-22-2015 Looks nice. What is the slope at back top of drawer for? Re: Lingerie Chest: Designing the Drawers - Derek Cohen - 11-22-2015 The sides of the chest curve. The sides of the drawer curve to fit it, front and back. The angles are the first step, then they are coped to fit the sides. Regards from Perth Derek Re: Lingerie Chest: Designing the Drawers - hbmcc - 11-22-2015 In the second to last image the drawer sides are tapered (shaped) down to the top of the back. Just wondered if the back blades/rails were oversize. Or, perhaps, it shows premature wear.... But it is only a test drawer back. Re: Lingerie Chest: Designing the Drawers - Derek Cohen - 11-22-2015 Sorry Bruce, I misread your question. The slope at the rear of the sides aids in fitting the drawers. It is also a finishing detail to the lower rear panel. Regards from Perth Derek Re: Lingerie Chest: Designing the Drawers - Window Guy - 11-25-2015 Derek nice looking project, great job. Steve |