don't cut duct tape on your band saw - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: don't cut duct tape on your band saw (/showthread.php?tid=7166932) |
don't cut duct tape on your band saw - DogwoodTales - 12-12-2015 Like the subject line reads - yes I was stupid enough to try it. My daughter had some of her patterned duct tape rolled onto a paper towel tube and asked me to cross cut it to a narrower width. stupid me didn't think about the consequences. I guess I had been in the shop too long and was brain tired. I spent the better part of a half hour cleaning that gunk off my blade and the lower wheel. So, for those of you who know better than I did, please be kind For those of you who don't (like me who didn't or just didn't think it through) ... you are forewarned. If I don't set a good example, then I'll just have to serve as a horrible warning. Re: don't cut duct tape on your band saw - PhilJoines - 12-13-2015 I've always used a meat slicer. Re: don't cut duct tape on your band saw - ruffcutt - 12-13-2015 PhilJoines said:+1 Re: don't cut duct tape on your band saw - Steve N - 12-13-2015 Bandsaw works fine, as long as it's not yours Old rip saws with a bent blade. Shorten them, and they can/will cut a lot if you aren't in love with them Tip: If you do need to cut a roll of tape, it helps if you do start with a BS, use it to cut a rough circle approximating the inside diameter of the roll out of some scrap 2x4 material. Use that circle to keep the roll from squishing down as you cut it. Re: don't cut duct tape on your band saw - Leinie - 12-13-2015 Don't feel bad, Once when I was younger and dumber- I had a 4" roll of sticky back sand paper, but only a 3" holder/sanding block. Yep, I cut the 4" roll with the radial arm saw. The 80 tooth carbide did a nice job of cutting the roll, but it didn't cut wood worth a darn afterwards. Re: don't cut duct tape on your band saw - Bill_de - 12-13-2015 As long as you didn't mess up the stuff your daughter asked you to cut, all is good! -- Re: don't cut duct tape on your band saw - paarker - 12-13-2015 I also wouldn't cut a 2 inch roll of painter tape either. Re: don't cut duct tape on your band saw - CanoeBoy - 12-13-2015 AND Don't cut coconuts on a Table Saw. Re: don't cut duct tape on your band saw - gMike - 12-13-2015 Don't cut up rawhide dog bones on a band saw either. The results are, umm, unexpected. Re: don't cut duct tape on your band saw - Superglide - 12-13-2015 Or a pinky finger...... It hurts..... |