+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: splitting a log question (/showthread.php?tid=7226932)
splitting a log question - overland - 02-22-2016
There is an ash log here about 43 inches long by 22 inches in diameter. I have two steel wedges. Will I be able to split it--or will I lose my wedges? Any advice? I don't know if I should try.
Re: splitting a log question - Bibliophile 13 - 02-22-2016
Possibly. Drive them in close together, and as you drive in the second, the first will come loose. If you do get both wedged in tight, then take that as a sign from the heavens that you need another splitting wedge.
You can also make large wedges out of hardwood. Seasoned hardwood is best, but even a stout branch can be cut into a wedge shape in a pinch. Big, long ones (12"-18" long) are especially helpful once you get a split started.
Re: splitting a log question - overland - 02-22-2016
Stupid question. Do I start on the side, or on the end?
Re: splitting a log question - AdamR - 02-22-2016
Not a stupid question at all. Start at the end and work down the side. It is much easier than you think. 2 wedges will work fine.
Re: splitting a log question - glzahn - 02-22-2016
Know anybody with a chainsaw? Have them rip it for you, it's like a portable bandsaw. I do it all the time.
Re: splitting a log question - PaulC - 02-22-2016
Two wedges is plenty. You may want to make a wooden 'glut' or two to hold things open as you progress. Curtis Buchanan has a good video showing the process.
Re: splitting a log question - overland - 02-22-2016
Where do I place the first wedge?
Re: splitting a log question - PaulC - 02-22-2016
At the end. (not in the end, but at the end of the side if you know what I mean)
Re: splitting a log question - MichaelMouse - 02-23-2016
overland said:
Where do I place the first wedge?
Most presume that you will split through the center, which is fine, if that's what you're after - bowl blanks. If you're looking for lumber, place your wedges where they straddle a favorable annual ring in a position meeting your thickness/width requirements. No real appearance advantage with quartered riven ash, so you might consider splitting round and round.
If you're going center, place wedges inside the sapwood on either side, drive alternately, and have a glut ready if you have a lot of hidden crossovers. Once the ends are opened, you can walk wedges/glut down the log. Or use a go-devil (maul).
Re: splitting a log question - Pink Floyd - 02-23-2016
Make a deep axe cut on the top edge of the log at one end. Place the wedge in that axe cut and drive it in. If the wedge wants to jump out when struck, stick the tapered end in the dirt and try again. The dirt will help it get a bite. Drive the first wedge in until a crack propagates and then place the second wedge in there. Rinse and repeat.
That log should split fairly easily as it's not very long. You will probably have to use an axe to cut some of the wood stringers between the two halves to get them completely apart.