Jointer issue? - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Jointer issue? (/showthread.php?tid=7257960) |
Jointer issue? - woodhead - 04-03-2016 I purchased new blades for my Delta 37-190, 6" jointer. One height set screw is stuck. Got a temp fix on it so I can use the tool. I tried muscle, heat and oil to get the screw loose, but the allen drive is shot in the screw. This is a special screw with a point. Can I drill the height nut (another special part) and get the set screw out? What to do about this screw, as it is no longer available? Freakin metric too! Al Re: Jointer issue? - mike4244 - 04-03-2016 Not actually being able to see the problem I'll take a shot at it. If you can cut a slot with a Dremel tool you may be able to unscrew the height screw.If not, try hot gluing an allen wrench in the screw. I imagine you are referring to the jack screws. I don't use them even though my jointer has them.If you really need that screw then buy a similar threaded screw.Put a point on the screw after cutting to length.Put a screw in your drill head on jaws.Rotate the drill chuck against the rotation of the grinder wheel til you get a point. Run a die over the thread to clean it up.Could be the screw is metric. You could re-tap for imperial threads if you want. mike Re: Jointer issue? - JGrout - 04-03-2016 get a metric screw as long as the original even without a pointed end You can do that yourself getting the other out probably should be done with care if you cannot find the holder but it is possible. A good setup in the drill press (bonus for a cross vice and using it) will either drill it out or maybe with some power behind the drill heat it enough to remove it. you may need a tap if the screw does not come out as you drill Re: Jointer issue? - PaulM85 - 04-03-2016 Have you tried an screw extractor. These have worked well for me in the past, http://www.lowes.com/ProductDisplay?part...w&cId=PDIO1 Re: Jointer issue? - woodhead - 04-04-2016 PaulM85 said: Thats too big. I see the part online, less the jack screw. They call it a nut, it is round with a flat to lift the blade. Probably a 1/2" in diameter. I did not want to mangle it and be left with nothing to work with. Al Re: Jointer issue? - JGrout - 04-04-2016 Seems these guys have the nuts so all you have to do is shell out the $$ and locate a metric set screw to fill the new nut found right here Re: Jointer issue? - museumguy - 04-04-2016 Well, if you can find the thread size and give me a length, I may be able to send a metric set screw. I have had to buy a quantity of them before when I only needed 1 or 2. Another option is to go to an Ace Hardware or True Value. They have those thread gauges and assorted set screws. You can probably get what you need there. Re: Jointer issue? - woodhead - 04-04-2016 Much appreciated! I needed new jointer blades and wanted a second set, so I bought from Holbren. I will order a new nut and deal with it later. Doubt I will have to change the blades for a while, as I don't use the tool too often. Thanks for everyones input. What I did do was use a soda can for shims under the jack screw. Just want to be prepared if the blade drops for some reason. Al |