+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Hope chest problems (/showthread.php?tid=7259860)
Hope chest problems - Peter Tremblay - 04-06-2016
Hello all,
I recently visited the person who bought my last hope chest. I had built it to benefit a charity auction to support the Catholic Grammar school where I was ministering up in Connecticut.
The Hope chest is walnut, lined with thick cedar boards and finished with arm-a-seal and then 3 coats of semi-gloss seal-a-cell.
The inside of the chest has gotten these sticky deposits of something, maybe resin?
I'm not sure what is the cause nor what the solution might be.
I'm wondering if all the natural oils from the cedar are "pooling" into these resin deposits on the inside of the chest?
That strikes me as improbable but I have no clue as to what is going on.
The only thing that has been stored in the chest are blankets.
Here are some pics.
If anyone has any thoughts or suggestions I'd appreciate it.
I'd like to figure out the cause and a way to clean it off without destroying the finish.
Thanks
Re: Hope chest problems - mbw - 04-06-2016
Peter is that oozing limited to the walnut?
Re: Hope chest problems - John Mihich - 04-06-2016
The gas from the cedar is doing that. I would remove the finish inside the top and use shellac.
Re: Hope chest problems - Pink Floyd - 04-06-2016
John Mihich said:
The gas from the cedar is doing that. I would remove the finish inside the top and use shellac.
Agree. The oils in the ERC are softening the finish on the Walnut...not unusual with that much Cedar in an enclosed box. John's advice to remove the existing finish and re-coat with shellac is good.
Re: Hope chest problems - Peter Tremblay - 04-06-2016
mbw said:
Peter is that oozing limited to the walnut?
Great question.
If I remember (and I can double check) I think it is limited to the walnut.
Re: Hope chest problems - Peter Tremblay - 04-06-2016
Pink Floyd said:
[blockquote]John Mihich said:
The gas from the cedar is doing that. I would remove the finish inside the top and use shellac.
Agree. The oils in the ERC are softening the finish on the Walnut...not unusual with that much Cedar in an enclosed box. John's advice to remove the existing finish and re-coat with shellac is good.
[/blockquote]
The oils won't react with shellac?
Should I refinish the entire chest?
Can I blend the finished (if I don't refinish the entire thing) so that the shellac matches the finish outside of the chest?
Re: Hope chest problems - John Mihich - 04-06-2016
I'm assuming this was only on the inside. You don't have to redo all of it if it's just the inside. You could just strip the inside and wax it.
I suggested shellac because the off gassing is minimal and should not react to the gas from the cedar. I have used both shellac and lacquer for lids. I stay away from poly or oils for anything that will be enclosed.
Re: Hope chest problems - gMike - 04-06-2016
John Mihich said:
The gas from the cedar is doing that. I would remove the finish inside the top and use shellac.
I'm confused. Is the gas coming from the cedar or the finish? I never knew cedar outgassed...
Re: Hope chest problems - bhh - 04-06-2016
http://www.rockler.com/how-to/apply-finish-interior-cedar-blanket-chest/
Re: Hope chest problems - John Mihich - 04-06-2016
bhh provided the best answer.