+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: 5 Cut Method (/showthread.php?tid=7262084)
5 Cut Method - RJT123 - 04-09-2016
I put a new sacrificial fence on my Incra Express/1000SE sled. Gave me a chance to try the 5 cut method to align it to the blade. Followed this guys link:
http://valleywoodworkers.org/wp-content/uploads/2014/01/5CutMethodSquare.pdf
Very nice, feeler guages, who knew? Sled is now way more square than is necessary for wood.
Just truing up all my machines for making new kitchen cabs.
Re: 5 Cut Method - mikefm101 - 04-09-2016
I used this method last weekend for a small crosscut sled. Some test cuts were .0002" error ratio.
Making a new large sled soon and will use the same procedure.
Mike
Re: 5 Cut Method - Steve N - 04-09-2016
the William being referenced is William Ng. He shows the 5 cut along the way to building a very accurate sled in this video.
https://www.youtube.com/watch?v=UbG-n--LFgQ
Though I believe the 5 cut was around before William was a zygote
