+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Rubbing out a waterborne finish? (/showthread.php?tid=7262400)
Rubbing out a waterborne finish? - johndi - 04-10-2016
I just finished a coffee table with waterborne poly. I put 6 coats on the top, and decided that I should use the last of the finish in the can after the last coat. There wasn't enough left to cover the entire top.
Now looking at the top in raking light I can see that last coat because it is thicker than the last.
I have never used waterborne before, it's what I had on hand.
Is there a technique for rubbing out the finish to level it? Thinking about light sanding with 500 grit. I used a gloss finish and don't want to dull the top.
Thanks
Re: Rubbing out a waterborne finish? - jteneyck - 04-10-2016
I would sand the top with 320 or 400 grit until it's dead smooth and then apply one or two more coats of finish. Yeah, you'll have to buy another can, but that's a better solution than trying to rub out overlapping layers to look like one.
John