+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Veneering of door styles question (/showthread.php?tid=7266186)
Veneering of door styles question - joemac - 04-15-2016
I am building an Arts & Crafts armoire from QSWO. On the door I want to employ a veneer that has Stickley inlaid decorations on it for each style. I glued the veneer to the QSWO styles and am waiting for them to dry.
It just occurred to me that the edges of the veneer will not be protected in any way. I am concerned that the edges would easily chip off. Are my fears unfounded? If not, any ideas of what I can do to protect the edges so they do not chip or de-laminate?
Re: Veneering of door styles question - Rob Young - 04-15-2016
A good quality job gluing down the veneer helps. A very light chamfer will also help.
Re: Veneering of door styles question - joemac - 04-15-2016
I used veneer glue and applied it with a roller, getting a consistent good coat. I sandwiched the board between two pieces of MDF and used ten parallel clamps, alternating sides, on a style 6" wide by 54" long. It will remain in the clamps for three weeks. (I can't get back to the shop till then)
Re: Veneering of door styles question - Rob Young - 04-15-2016
joemac said:
I used veneer glue and applied it with a roller, getting a consistent good coat. I sandwiched the board between two pieces of MDF and used ten parallel clamps, alternating sides, on a style 6" wide by 54" long. It will remain in the clamps for three weeks. (I can't get back to the shop till then)
I suspect the glue will be dry by then.
Re: Veneering of door styles question - rwe2156 - 04-19-2016
This is what cockbeading is for.
Any kind of inlay strip or edge banding would work.
Re: Veneering of door styles question - Mike Brady - 04-19-2016
Joe, can you post photos of that?...in three weeks, of course.
Re: Veneering of door styles question - joemac - 04-19-2016
Sure Mike, be glad to
Re: Veneering of door styles question - joemac - 05-23-2016
Mike Brady said:
Joe, can you post photos of that?...in three weeks, of course.
Mike, took a while but here they are:
First is the four week clamp up.
" /> And second is the finished style (there are two of these)
" /> I hope to get back up there this weekend and plug along on this epic build.