+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: So I've got these drill bits (/showthread.php?tid=7311025)
Re: So I've got these drill bits - Redman - 07-02-2016
Ted Jay said:
Brad Point Drill Bits are not for drilling metal but primarily used for wood. The spur cutting edges reduce splintering and ensure a smooth, clean hole.
You seem quite knowledgeable on drill bits. Perhaps you could help enlighten the OP.
Re: So I've got these drill bits - sweensdv - 07-02-2016
I think there's a tad bit of leg pulling going on here.
I find it hard to believe that Stwood really doesn't know what a brad point drill bit is.
Re: So I've got these drill bits - Redman - 07-02-2016
sweensdv said:
I think there's a tad bit of leg pulling going on here.
Ya think?
Re: So I've got these drill bits - JGrout - 07-02-2016
sweensdv said:
I think there's a tad bit of leg pulling going on here.
How are you doing? Taking up fishing I see
Re: So I've got these drill bits - daddo - 07-02-2016
These videos will save a lot of explaining and time.
https://www.youtube.com/watch?v=L53FQrXOgVE
https://www.youtube.com/watch?v=y0SQkzScQk0
https://www.youtube.com/watch?v=HDEyDKj2R9U
https://www.youtube.com/watch?v=pdshIBOox4M
Re: So I've got these drill bits - Stwood_ - 07-02-2016
I'm getting confused.
Re: So I've got these drill bits - Redman - 07-02-2016
Don't let a little confusion bother you. Just take it one thing at a time. You might still be confused but not so bad.
Re: So I've got these drill bits - Stwood_ - 07-02-2016
How do you keep the mice out of your toolbox?
Oh, wrong thread. What happened to the thread?
Do you have brad points Red?
Re: So I've got these drill bits - Redman - 07-03-2016
Somewhere I may still have 1 brad point drill. Tried it with a doweling jig many years ago. Regular general purpose drill would have been just as good.
Re: So I've got these drill bits - Arlin Eastman - 07-03-2016
You are one funny guy. Is this April 1.