+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: A glue question (/showthread.php?tid=7316486)
A glue question - MIKE28 - 07-11-2016
I have a customer that has some Formica covered
doors that he would like some Pine slates glued to
the front, I have always used Titebond ll for all my
woodworking projects but I wonder if any of you
guys have tried this and what kind of glue you used.
I was going to sand the area with 60 grit sandpaper
I could sure use some help on this one.
Thanks
Mike D
Re: A glue question - JGrout - 07-11-2016
I assume shiplapped pine?
Titebond any one will not work well in this application
how big are the doors?
and what sort of clamping choices do you have at your disposal.
Re: A glue question - MIKE28 - 07-11-2016
They are cabinet doors 28x18
he wants 2 inch x 1/4 inch slats glued
to the outside edge of the Formica front of each door
Re: A glue question - JGrout - 07-11-2016
for the perimeter I would use Gorilla glue (This is one of the few times you will ever see me suggest this Glue.)
I would make a couple of kerf cuts on the inside about 1/4" from that edge about 1/8" deep (a glue trap). Rough up the formica as you stated, wet the formica (yes wet it not a lot just wet. Then (and this will take some experimenting) add gorrilla glue to the two parts spread it out with a credit card or similar then cover the pine with a caul and clamp it to the door with clamps at least every 8"
After the glue has cured you can trim the excess off the outside edges with a sharp chisel
The kerf if done correctly should trap the glue preventing it from migrating to the inside of the door slab. that is why it is important to control your glue to just enough to keep the mess to a minimum
Re: A glue question - Gary G™ - 07-11-2016
You might try Lexel--glues anything to just about anything.
Re: A glue question - Steve N - 07-11-2016
The wood portion is fairly easy, plenty of stuff to adhere to wood, particular if it is roughed up a bit. Formica is basically a paper sandwich, with an abundance of glues, and surface protectors applied between layers, and coated on top. You first need to really clean it up. Murphys oil soap or a prep wash like that will remove kitchen grease and grime. Then you might want to scratch sand the surface to get a base the glue can stick to. Gorilla glue or one of those sticks to anything wonder glues will likely get it done. If I was doing it I would find some scrap Formica, or buy a sink cutout to experiment with to see if it is doing what you want it to.
Re: A glue question - mike4244 - 07-12-2016
Nickel size dots of panel adhesive.
mike
Re: A glue question - Joel H. - 07-12-2016
Make new doors. Maybe not cheaper, but neater & easier.
Unless of course, it matches cabinets. Then disregard this post.
Joel