Schadenfreude Monday - Printable Version +- Woodnet Forums (https://www.forums.woodnet.net) +-- Thread: Schadenfreude Monday (/showthread.php?tid=7321459) |
Schadenfreude Monday - Aram - 08-08-2016 Glue in many dowels. Remove with flush cut saw and chisels to make room for router. Re-drill dowel holes. Set 7/16" groove depth by setting a square to 1/2" and then adding 1/16, because 8+1=7. Glue in dowels on both sides of mating pieces. Remove with flush cut saw and chisels. Re-drill dowel holes. Don't even ask my how I managed to set my 15HH planer to something like 3/8" -- much less how did I get the board in there? -- and am now deep in a dicey gearbox scenario. Feel better now? Happy Monday. RE: Schadenfreude Monday - jteneyck - 08-08-2016 Ouch, ouch, ouch, ouch, ouch, and yowzer. And that was only this morning? Time to quite and contemplate tomorrow being better. A six pack or three couldn't hurt. And may I suggest you resist the temptation to turn the planer on if you have any parts left over after the repair. John RE: Schadenfreude Monday - Aram - 08-08-2016 (08-08-2016, 01:08 PM)jteneyck Wrote: Ouch, ouch, ouch, ouch, ouch, and yowzer. And that was only this morning? Time to quite and contemplate tomorrow being better. A six pack or three couldn't hurt.To my credit I did spread it out over the weekend. This is just a Monday morning recap for your entertainment. I got the planer back into gear and it seems to run ok. Dunno. I'll probably take it apart to be sure. The rest, well, at least I used up my yearly allotment of dumb, and it's not even the end of summer. Clear sailing from here to New Year's day. Right? Just nod yes. RE: Schadenfreude Monday - fredhargis - 08-08-2016 (08-08-2016, 01:43 PM)Aram Wrote: To my credit |