+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Odds and ends (/showthread.php?tid=7326254)
Odds and ends - TheCabinetmaker - 12-17-2016
All items are plus postage. Paypal friends and family ok.
1. Older 10" 4 jaw chuck. Their is no adapter plate so you will have to make your own. Should clean up nice. A new one runs $2,000.00 on Grizzly So how about $200.00 This will fit into a large flat rate box.
![[Image: P1000934_zpslmy3ssku.jpg]](http://i447.photobucket.com/albums/qq193/thecabinetmaker/P1000934_zpslmy3ssku.jpg)
2. Foley 392 setter $25.00 plus shipping weighs around 35 pounds .
![[Image: P1000935_zpsyfdpqohk.jpg]](http://i447.photobucket.com/albums/qq193/thecabinetmaker/P1000935_zpsyfdpqohk.jpg)
3. Crucible unused $50.00 plus shipping
![[Image: P1000937_zpsqavsa2rp.jpg]](http://i447.photobucket.com/albums/qq193/thecabinetmaker/P1000937_zpsqavsa2rp.jpg)
![[Image: P1000936_zpsofr31jlv.jpg]](http://i447.photobucket.com/albums/qq193/thecabinetmaker/P1000936_zpsofr31jlv.jpg)
4. Hard Maple Rammers unused. These are solid hard maple not glued up. These look like they could make a good mallet I you cut off the bottom. $15.00 each plus postage
![[Image: P1000938_zpsiusuhvtr.jpg]](http://i447.photobucket.com/albums/qq193/thecabinetmaker/P1000938_zpsiusuhvtr.jpg)
RE: Odds and ends - iclark - 12-17-2016
What are the dimensions on the rammers?
RE: Odds and ends - TheCabinetmaker - 12-17-2016
They are approximately 3" in diameter and 14" long