+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Shelf standards (/showthread.php?tid=7326284)
Pages:
1
2
Shelf standards - KC - 12-18-2016
I have a lot of shelves in the garage. Took things down to rearrange and repaint, and those shelf standards pretty well destroyed the paint all around them when they came off. Utility hooks (the big 'J' hooks) do the same thing. Anything that touches the paint sticks to it. I expect the builder used cheap paint, and sprayed one crappy coat of semi-gloss over the very heavy knock down texture. I've been hanging stuff with these forever, but usually used flat paint... and I never had this issue before. Difficult to repair that heavy texture... and compounded by the noticeable difference in the quality of 'finish' work they put into the garage walls as opposed to the house. It IS a garage... but still. I've already decided that should we move one day, somebody's gonna get a garage full of shelving and cabinets.
RE: Shelf standards - fredhargis - 12-18-2016
I've always had that happen, even with the "good" quality paints. On larger spots it's normal (in my experience) to have the paint pull the paper right off the sheet rock. In my last shop, that's exactly what happened in places like where the frame for the DC was bolted to the wall....fairly steep damage. I had explained this in my "disclosures" when the place was listed, and got no complaints form the buyer. I just consider it one of the problems with latex paint.
RE: Shelf standards - Robert Adams - 12-18-2016
Same issue here. With good or bad paint it causes problems like that.
I really hate the texture that they put on walls here in tx. The knockdown they use now isn't bad but the 80s heavy texture is awful. Ours is a 1960 and it's not as heavy but still a royal pain.
Our next house will have smooth walls as I hate texture as its impossible to repair without redoing the whole room and a pain to paint.
RE: Shelf standards - Mr_Mike - 12-21-2016
Texture isn't that bad to match. The aerosol cans at home depot do a pretty good job. Not like popcorn on the ceiling, that can't be matched.
Regarding the paint. Use an enamel paint. It should be less sticky.
RE: Shelf standards - KC - 12-21-2016
(12-21-2016, 02:28 PM)Mr_Mike Wrote: Texture isn't that bad to match. The aerosol cans at home depot do a pretty good job. Not like popcorn on the ceiling, that can't be matched.
Regarding the paint. Use an enamel paint. It should be less sticky.
This is very heavy texture, and the problem is knocking it down in the repair area without just making it look like a giant patch because the knife is riding on the existing texture. You'd probavbly have to look to see the repair, but once you found it it's pretty obvious.
RE: Shelf standards - Woodjets - 12-22-2016
Use a latex ceramic paint if you want to reduce the stickiness.
Also, stay away from cheap paints; the fewer the coats needed, the less likely you'll experience the problem you've come across. The higher end Benjamin Moores and Sherwin Williams perform well. They are pricey so ask for a discount.
RE: Shelf standards - EricU - 12-23-2016
we have texture in the basement stairwell for some reason. I was thinking it was the only place, but they also did it in the closets. I have been thinking of skim coating the stairwell.
I don't know if it would help this situation any, but I have become a big fan of primer. It really sticks. I'm not trying to make a living at painting, so going over it one more time is no big deal.
RE: Shelf standards - Snipe Hunter - 12-29-2016
One of the first things I noticed when moving to the east coast is that you almost never see textured drywall here. Some of the older homes had popcorn or textured ceilings but almost never on walls. It's definitely a western thing, along with stucco.
RE: Shelf standards - rwe2156 - 12-29-2016
When removing trim, etc scoring all around with a utility knife prevents tearing the paint.
RE: Shelf standards - meackerman - 12-29-2016
texture is a lot faster/cheaper than plastering the walls.