Woodnet Forums
Table top finished - Printable Version

+- Woodnet Forums (https://www.forums.woodnet.net)
+-- Thread: Table top finished (/showthread.php?tid=7328301)



Table top finished - Bope - 02-27-2017

So here are pictures of the finished table top. I still need to paint the base. I was thinking of staying with a brown color.

[Image: Table%20top2.jpg]

[Image: Table.jpg]


RE: Table top finished - jteneyck - 02-27-2017

That top is beautiful.  It looks like you mastered the EnduroVar in the end. 

John


RE: Table top finished - JGrout - 02-27-2017

I would say you did just fine. 

That is very intricate work and you nailed it.

Joe


RE: Table top finished - Bope - 02-27-2017

The sides are still rough. I need to call General Finishes this week and see if I can get new material.


RE: Table top finished - jteneyck - 02-27-2017

If you have good coverage and it's just rough from over spray, etc., then take some 1500 grit sand paper and buff it smooth by hand.  Or get some Micro Mesh pads.  If the sheen is off, go higher or lower on the grit.  

John


RE: Table top finished - Bope - 02-28-2017

I will give that a try. I was worried about the changing the sheen. If I do mess it up I can always shoot another coat.