+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Got bored today (/showthread.php?tid=7329620)
Got bored today - bandit571 - 04-19-2017
And decided to work on a $1 saw I have had for a while...actually bought three saws last year....one was a plastic handled Atkins..Meh
Second one was a wood handled Disston/HK Porter crosscut. Blacksilk screen "etch" appears to say "Journeyman"
[attachment=2016]
Meh.
Not the best on the block. As for number 3.....it's handle was a plain version, and just as blocky as this one. No hanger hole, though.. 
Took the handle off the plate, cleaned both. Sanded down the sharp edge on the handle, until it felt better in the hands. Hardware was polished up..
Handle was given a coat of "wipe on, wipe off" Witch's Brew....So, how did this other saw turn out?
[attachment=2017]
The medallion side, with the more rounded edges..
[attachment=2018]
Back side, showing the clocked screws. and the entire saw?
[attachment=2019]
Not too bad. 8ppi, 26" long crosscut. Disston USA. Still trying to see an etch...
See what happens, when I get bored?
RE: Got bored today - JimReed@Tallahassee - 04-20-2017
Good job. Another saw saved from those infernal "daisy painters".
RE: Got bored today - Arlin Eastman - 04-21-2017
Bandit
Someday I will buy a Rip and Crosscut saws for us.
RE: Got bored today - bandit571 - 04-21-2017
Well, the second saw will get used as a Rip saw
[attachment=2031]
Very late model Disston/HK Porter 8 ppi,26" long saw
[attachment=2032]
Went over the teeth with a file...not enough set for cross cutting, but, just the right amount for a rip cut....
Saw is now in the til....
RE: Got bored today - bandit571 - 04-23-2017
First saw was a T-1 Townsman 1955 after HK Porter bought out Henry D.
Second saw is a C-1 Countryside made a bit later than the first saw.
Both are 26" long, straight back, 8 ppi saws.
About all the info I have on these two saws..