+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Another Road Trip? (/showthread.php?tid=7329859)
Another Road Trip? - bandit571 - 04-29-2017
Well.....Friday Garage Sales....were a bust. only one was opened, anyway....nothing I needed. had to drive to pick up the GrandBRATS later....part of the route took me past a little store, again..
Afraid i spent most of my allowance on two tools
even then, I got $2 off. [attachment=2124]
4" x 24" backsaw, maker unknown.....Medallion says Warranted Superior. SHARP, well set teeth. As for the little eggbeater...
[attachment=2125]
Buck Rogers No. 104 by Millers Falls. Had a spot or two of rust on the chuck, was missing the drill bits from the inside of the handle
Total price was $11 for the two. May have paid too much
$4 for the drill, $7 for the saw. Might have been worth the stop?
RE: Another Road Trip? - hbmcc - 04-29-2017
Nice haul. Justifies the fuel cost. Unless you are walking ....
When I do donations will check the attached store for stuff I can't leave behind. Rarely spend over $5. The last trip gave me a Disston with one of those wart thingies on top of the plate for $2. Can't push a western saw, but status quo must be biting. I'll try to clean it. Garage sales are the equal of stroke and heart failure combined, so we never look for those; passing a yard sale is bad enough.
RE: Another Road Trip? - bandit571 - 04-29-2017
Ever try to drive past a sale...when you can smell the rust from the street? Have turned around more than a few times, gone back and found a rusty bit of Goodness waiting to be picked up.....like a Minty D-23 8ppi...for free? Maybe a Stanley SW No. 4, type 13...for $2? Some days, it s just the thrill of the hunt......never knowing what there will be on a table somewhere......
Drill was made between 1949 and 1960.......not sure about the saw, yet. Last 4" x 24" back saw cost me $20......$7 sounds a little bit better?
RE: Another Road Trip? - bandit571 - 05-01-2017
Ok, saw has been cleaned up, and taken for a test drive..
[attachment=2139]
Had to raise the depth stops a hair....otherwise, it cuts into the deck..
[attachment=2140]
Swung the mitre box around for a 45 degree cut, just to show off the saw...
[attachment=2141]
Might just be worth the $7 I paid for it?
Cleaned the price tags off the Millers Falls No. 104 drill.....he used a sharpie to mark it.....might need to open it up, and add a spot of oil inside....not sure which oil they used, though..
Price was marked as $5, got it for $4. Works for me...
RE: Another Road Trip? - bandit571 - 05-04-2017
There is to be one of those "Village wide garage sale" days on the 25th of this month....might be something worth the walk around that village....
RE: Another Road Trip? - Bill_Houghton - 05-08-2017
Clearly, you need to go on more road trips. Pretty decent suckage there.
The M-F eggbeater drill is a nice thing to have if you've got little ones in the shop - exposed gear mechanisms are invitations to pinched kid parts - arms, fingers.