+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: What is this plane? (/showthread.php?tid=7329956)
What is this plane? - Tynyyn - 05-02-2017
https://www.youtube.com/watch?v=-dG786kOBjw
Jump to 6:00 and there is a miniature version of a Stanley 10 1/2. Does anybody have a number for this plane and manufacturer?
Thanks.
RE: What is this plane? - AHill - 05-02-2017
It's a Lie-Nielsen rabbet block plane. There is no Stanley equivalent. The LN plane is based on the Sargent No. 507.
RE: What is this plane? - hbmcc - 05-02-2017
A neat design. It will trim flush to sidewalls. Perfect for this demonstrated use. There is built weakness in the arched sidewalls so they require care in use and storage.
RE: What is this plane? - Bill_Houghton - 05-03-2017
And, for someone thinking, "This is the solution!", Lee Valley takes a different approach that I think is a physically stronger design, at the cost of not planing both sides from the same plane:http://www.leevalley.com/us/wood/page.aspx?p=65373&cat=1,41182,41192&ap=1
[/url]
[url=http://www.leevalley.com/us/wood/page.aspx?p=65373&cat=1,41182,41192&ap=1]
![[Image: 05p7601s6.jpg]](http://www.leevalley.com/us/images/item/Woodworking/Planes/05p7601s6.jpg)
RE: What is this plane? - AHill - 05-03-2017
Traditionally, you'd trim tenons (and half-lap joints) with a shoulder plane. The wider, rabbet plane does offer some advantages for surfaces that are wider than a shoulder plane. A skew plane would work just as well. No need to have a left or right-handed skew plane for tenons or lap joints, given you're planing cross grain or end grain. As Bill points out, the left or right handed versions of skew planes are useful for long grain work.
RE: What is this plane? - RB61 - 05-03-2017
$109 Rabbet block plane
https://www.finetools.com.au/products/luban-rebate-block-plane
RE: What is this plane? - Arlin Eastman - 05-09-2017
So the only thing that keeps that plane from breaking is the thickness of the metal of the arch's. It does not look to strong to me.
RE: What is this plane? - AHill - 05-09-2017
(05-09-2017, 04:00 PM)Arlin Eastman Wrote: So the only thing that keeps that plane from breaking is the thickness of the metal of the arch's. It does not look to strong to me.
Plenty strong, Arlin. It's not just the thickness, but the width of those arches. Probably ductile iron, and stress-relieved (whether by heat treatment or aging) at that. I doubt many of us in the forum could bend it using only our own two hands. The Stanley 10-1/2 or its LN equivalent have wider arches, but it also has a larger blade. Used properly, the entire sole is in contact with the wood, so it would be very hard to impart bending stresses large enough to cause the body to deform. Especially as a trimming plane, where you're taking off thin shavings.
RE: What is this plane? - Bill_Houghton - 05-09-2017
The Stanley planes are gray, or at least not ductile, iron. It's very common for those arched sides to break. That's probably why my 10-1/2 cost me $6, years back: one side was cracked through. Fortunately, I had an uncle who could weld it.