Woodnet Forums
More door lock questions/issues - Printable Version

+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: More door lock questions/issues (/showthread.php?tid=7331921)

Pages: 1 2


RE: More door lock questions/issues - woodhead - 07-23-2017

edit to add: your key issue is one of the clues the slide bolt is near failure 


No, silly, the key was worn!  ..and binding.


Quickset = cheap POS  
Homeowner Schlage better
Baldwin... more money but better.


Al


RE: More door lock questions/issues - JGrout - 07-23-2017

that is a huge amount of wear 


Uhoh


RE: More door lock questions/issues - jteneyck - 07-24-2017

(07-23-2017, 06:55 PM)JGrout Wrote: do you know which way the lock is sticking? forward/aft or top/bottom  a coating of lipstick on the slide should give you some clues fairly fast 



Joe

I was trying to figure out what one could use to see where the deadbolt was rubbing.  Lipstick - but of course.  I've learned another great tip.  Thanks.

John


RE: More door lock questions/issues - woodhead - 07-24-2017

(07-23-2017, 09:19 PM)JGrout Wrote: that is a huge amount of wear 


Uhoh

If it was a cheap replacement type key, then not surprised, especially if he has to use it twice to unlock and once to lock. Could be bent too??? Happens when you have to force a dead bolt open every day.



Al


RE: More door lock questions/issues - mike4244 - 07-24-2017

Has the margin changed from one season to another? If your door is sagging the latch and dead bolt will be to low.
Remove top screw on both the jamb and hinge side . Re-install a long screw with the same size head. Then repeat on the next screw down. Two should be enough to keep the door from sagging. The latch and bolt may fit the strike plate now. 
If the problem is the door itself , swelling wider in the humidity then a new door is an option. I did fix one door that swelled at the mid rail only. I found that I could pull the joint tight with a bar clamp. I talked to the owner and gave her a couple of options. First was to peg the door stiles to the rail mortise. Second was to bore a hole for a threaded rod thru the stiles and rail horizontally. I told her no guarantee as this was more difficult then the first option. 
The door was a custom made door that cost her $2100.00 installed. She had contacted the installer first , no help from him. The shop that made the door had changed hands and the new owner claimed no liability.
She went for the threaded rod as one hole was concealed by the mortise lock and the other I plugged on the hinge side. Took me about 2-1/2 hours total . About 2 hours boring the hole and installing a 3/8" acme threaded rod.
I happened to have an acme rod left over from other work. Been 6 years now and the door is still intact ,no swelling. If you go this route , PM me and I'll explain how to bore thru the door without blowing thru the face. Takes a exact set up and the correct drills and extension.
mike


RE: More door lock questions/issues - daddo - 07-24-2017

I made a custom striker plate for our door for this reason. I made it with a 2" oblong hole so when the door goes up and down with the rain, it always opens.