+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Saturday morning Garage sale.... (/showthread.php?tid=7334079)
Saturday morning Garage sale.... - bandit571 - 10-17-2017
Had a simple description...."Tools"....
So...15 minute drive, spend $9....plus what the Boss bought
Picked five items...should have gotten a lot more 
but, I am trying to maintain some self control 
( this may take a few posts.....
)[attachment=5093]
@ $2 each...Shelton No. 18 Low Angle block plane, and a Millers Falls #900 ( 1950)
[attachment=5094]
A pair of French Goldenberg planes.....about a #3 size....maybe even a #2? ( irons are 1-5/8" wide)
And, for just a dollar bill..
[attachment=5095]
26" long, skew back 8ppi, filed crosscut ( and VERY SHARP!)....
[attachment=5096]
Richardson Brothers No. 8 As for the french logos...
[attachment=5097]
Cast steel, warranted....
Next episode will be the rehab....stay tuned...
RE: Saturday morning Garage sale.... - bandit571 - 10-17-2017
Ok, the iron/steel planes first...
[attachment=5098]
Shelton No. 18
[attachment=5099]
And the Millers Falls No. 900
[attachment=5100]
Rear handle was cracked, and taped up.
Removed the tape, glued the parts back together... [attachment=5101]
Sharpened the iron so it could make some shavings....
Tried to rehab one of the French planes...
[attachment=5102]
This was as good as I could get it....was just too much wrong with that 1875 wood body....too much wear & tear...
Next episode coming right up ( not boring anyone?
) Stay tuned
RE: Saturday morning Garage sale.... - bandit571 - 10-17-2017
Ok, episode three....Remember all these treasures cost me a whopping $9....
The Richardson Brothers No. 8 saw, all cleaned up..
[attachment=5103]
Did NOT need sharpened.
Shined the brass a bit..[attachment=5104]
Note that they used a smaller bolt for the bottom one? They called it an "Extra Rivet"
[attachment=5105]
Tried to "clock" the slots.....medallion one seemed to be in a different "Time Zone"
Gave up on the first French plane....second one is still be worked on....may need a new wedge..
[attachment=5106]
Bit fancier..has two logos
[attachment=5107]
One for the iron, one for the chipbreaker. Wedge is lopsided, too slick, too beat up.....after a trip or two along a board, I needed to adjust the cutter....wedge kept sliding out.
I have some Hard Maple to use for a new wedge....we'll see. Not too bad of a haul, for $9 ?
RE: Saturday morning Garage sale.... - hbmcc - 10-18-2017
Cool! It's fun to watch other people collect and hoard, too. Mine is just everything....
RE: Saturday morning Garage sale.... - Tynyyn - 10-18-2017
The French planes will probably be cutting to the left constantly. Good haul, but could you tell if the owner was a previous woodworker or was he just somebody who collected things? Pretty rare in these parts to see any European tools.